解法:(文章太長,沒時間幫您翻譯...)
The following instructions pertain to all current and recent Symantec antivirus products, including the Symantec AntiVirus and Norton AntiVirus product lines.
1.Disable System Restore (Windows Me/XP).
2.Update the virus definitions.
3.Restart the computer in Safe mode.
4.Run a full system scan and delete all the files detected as W32. Spybot.Worm.
5.Delete the value that was added to the registry.
6.Delete any zero-byte files in the startup folder.
For specific details on each of these steps, read the following instructions.
1. Disabling System Restore (Windows Me/XP)
If you are running Windows Me or Windows XP, we recommend that you temporarily turn off System Restore. Windows Me/XP uses this feature, which is enabled by default, to restore the files on your computer in case they become damaged. If a virus, worm, or Trojan infects a computer, System Restore may back up the virus, worm, or Trojan on the computer.
Windows prevents outside programs, including antivirus programs, from modifying System Restore. Therefore, antivirus programs or tools cannot remove threats in the System Restore folder. As a result, System Restore has the potential of restoring an infected file on your computer, even after you have cleaned the infected files from all the other locations.
Also, a virus scan may detect a threat in the System Restore folder even though you have removed the threat.
For instructions on how to turn off System Restore, read your Windows documentation, or one of the following articles:
"How to disable or enable Windows Me System Restore"
"How to turn off or turn on Windows XP System Restore"
For additional information, and an alternative to disabling Windows Me System Restore, see the Microsoft Knowledge Base article, "Antivirus Tools Cannot Clean Infected Files in the _Restore Folder," Article ID: Q263455.
2. Updating the virus definitions
Symantec Security Response fully tests all the virus definitions for quality assurance before they are posted to our servers. There are two ways to obtain the most recent virus definitions:
Running LiveUpdate, which is the easiest way to obtain virus definitions: These virus definitions are posted to the LiveUpdate servers once each week (usually on Wednesdays), unless there is a major virus outbreak. To determine whether definitions for this threat are available by LiveUpdate, refer to the Virus Definitions (LiveUpdate).
Downloading the definitions using the Intelligent Updater: The Intelligent Updater virus definitions are posted on U.S. business days (Monday through Friday). You should download the definitions from the Symantec Security Response Web site and manually install them. To determine whether definitions for this threat are available by the Intelligent Updater, refer to the Virus Definitions (Intelligent Updater).
The Intelligent Updater virus definitions are available: Read "How to update virus definition files using the Intelligent Updater" for detailed instructions.
3. Restarting the computer in Safe mode
Restart the computer in Safe mode. All the Windows 32-bit operating systems, except for Windows NT, can be restarted in Safe mode.
NOTE: The following instructions are basic and can vary slightly depending on the operating system.
If the computer is running, shut down Windows and then turn off the power.
Wait 30 seconds, and then turn on the computer.
Start tapping the F8 key.
When the Startup Menu appears, ensure that the Safe mode option is selected. In most cases, it is the first item in the list and is selected by default. (If it is not selected, use the arrow keys to select it.)
Press Enter. The computer will start in Safe mode. This can take a few minutes.
When you are finished with all the troubleshooting, close all the programs and restart the computer as you normally would.
4. Scanning for and deleting the infected files
Start your Symantec antivirus program and make sure that it is configured to scan all the files.
For Norton AntiVirus consumer products: Read the document, "How to configure Norton AntiVirus to scan all files."
For Symantec AntiVirus Enterprise products: Read the document, "How to verify that a Symantec Corporate antivirus product is set to scan all files."
Run a full system scan.
If any files are detected as infected with W32.Spybot.Worm.
Write down the filenames, and then click Delete.
5. Deleting the value from the registry
CAUTION: Symantec strongly recommends that you back up the registry before making any changes to it. Incorrect changes to the registry can result in permanent data loss or corrupted files. Modify the specified keys only. Read the document, "How to make a backup of the Windows registry," for instructions.
Click Start, and then click Run. (The Run dialog box appears.)
Type regedit
then click OK. (The Registry Editor opens.)
Navigate to the key:
HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows\CurrentVersion\Run
In the right pane, delete any values that refer to the filename that was detected as infected with W32.Spybot.Worm.
Navigate to the key:
HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows\CurrentVersion\RunOnce
In the right pane, delete any values that reference the filename in step d.
Exit the Registry Editor.
6. Delete the zero-byte files from the Startup Folder
Follow the instructions for your operating system:
NOTE: There may be legitimate files on your system that start with "tftp." Make sure to only delete the zero-byte files from the Startup folder.
Windows 95/98/Me/NT/2000
Click Start, point to Find or Search, and then click Files or Folders.
Make sure that "Look in" is set to (C

and that "Include subfolders" is checked.
In the "Named" or "Search for..." box, type, or copy and paste, the file name, tftp*.*
Click Find Now or Search Now.
Delete the files that are zero-bytes and contained within any folder that ends with "Startup."
Windows XP
Click Start, and then click Search.
Click All files and folders.
In the "All or part of the file name" box, type, or copy and paste, the file names tftp*.*
Verify that "Look in" is set to "Local Hard Drives" or to (C

.
Click "More advanced options."
Check "Search system folders."
Check "Search subfolders."
Click Search.
Delete the files that are zero-bytes and contained within any folder that ends with "Startup."